33 32 051 Removing and installing/replacing left or right push rod/integral link

WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the integral link is detached from the wheel carrier or swinging arm, it is necessary after reinstallation to carry out a wheel/chassis alignment check. See 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION or 32 00 155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .

Necessary preliminary tasks:

Remove rear wheel.
Remove output shaft from rear differential . See 33 21 001 Removing and installing or replacing left output shaft or 33 21 002 Removing and installing / replacing right output shaft .

Support wheel carrier with workshop jack.

Release nut (1) and remove screw.

Release screw (2), press swinging arm downward and remove integral link (3).

Fig 1: Identifying Integral Link, Screw And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace self-locking nut.

First install swinging arm hand-tight, then tighten down screw (2).

Tighten screw/bolt connections in normal position . See 32 00... MOVING VEHICLE INTO NORMAL POSITION .

Tightening torque (nut) 33 32 22AZ . See 32 CONTROL ARMS AND STRUT .

Tightening torque (bolt) 33 32 21AZ . See 32 CONTROL ARMS AND STRUT .

After installation:

Check that output shaft is correctly seated in rear differential.
Perform chassis alignment check . See 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION or 32 00 155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .