32 34 020 Removing and installing/replacing airbag unit (Version 2)
WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use pictures in procedure to identify correct version
WARNING:
Observe the following instructions to avoid any risk of injury by the airbag unit.
- Comply with safety regulations for handling components with gas generators.
- Do not exert any force on the airbag unit.
- Use only specified tools for releasing the airbag unit.
NOTE:
Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT:
Steering wheel
must be replaced if airbag unit has been triggered!
Follow procedure after airbag triggering .
Follow procedure after airbag triggering .
Necessary preliminary tasks:
- Disconnect battery negative lead . See 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Insert Torx screwdriver T30 (1) at an angle into concealed opening on reverse side of steering wheel until a spring resistance is felt (approx. 2 cm).
Increase pressure with Torx screwdriver T30 (1) on spring leg until airbag unit is unlocked.
Repeat procedure on other side.
Fig 1: Inserting Torx Screwdriver T30 At Angle Into Concealed Opening On Reverse Side Of Steering Wheel
Installation:
Make sure electrical leads are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.
WARNING:
Risk of injury!
Airbag unit may only be set down with the airbag itself facing upwards .
Airbag unit may only be set down with the airbag itself facing upwards .
Tilt airbag unit (1) towards rear.
Disconnect plug connections (2) and remove airbag unit (1).
Installation:
Connect plugs to connections of same color on airbag unit.