32 34 020 Removing and installing/replacing airbag unit (Version 1)
WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use pictures in procedure to identify correct version
WARNING:
Observe the following instructions to avoid any risk of injury by the airbag unit.
- Comply with safety regulations for handling components with gas generators.
- Do not exert any force on the airbag unit.
- Use only specified tools for releasing the airbag unit.
NOTE:
Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT:
Steering wheel
must be replaced if airbag unit has been triggered!
Follow procedure after airbag triggering .
Follow procedure after airbag triggering .
NOTE:
To avoid airbag rattling on standard steering wheels, it is essential to replace the retaining plate together with the airbag unit.
Necessary preliminary tasks:
- Disconnect battery negative lead . See 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Insert T25/T27 Torx screwdriver (1) from below into hole (2) until a springy resistance can be felt through annular spring (3) of airbag unit.
Continue to press in T25/T27 Torx screwdriver (1) until airbag unit is released.
Installation:
Make sure connecting lines are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.
WARNING:
Risk of injury!
Airbag unit may only be set down with the airbag itself facing upwards .
Airbag unit may only be set down with the airbag itself facing upwards .
Build date up to 03/2007:
Disconnect plug connection (1) and remove airbag unit.
Build date after 03/2007:
Disconnect plug connection (1) and remove airbag unit (2).