32 41 ... Instructions for removing and installing ear clips

WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

32 1 260 . See STEERING AND WHEEL ALIGNMENT - SPECIAL TOOLS.
NOTE: The work steps are show on assorted components.
Ear clip must always be replaced.

To remove an ear clip, place special tool 32 1260 at right angles to ear and cut ear open.

Fig 1: Cutting Ear Clip
Courtesy of BMW OF NORTH AMERICA, INC.

The ear clip can be fitted not only axially but also radially after the hook fastener has been opened.

Fig 2: Identifying Ear Clip
Courtesy of BMW OF NORTH AMERICA, INC.

Attach hook fastener and press ear together with special tool 32 1 260 .

Fig 3: Pressing Ear Clip
Courtesy of BMW OF NORTH AMERICA, INC.

Side cutter of special tool 32 1260 can be used in areas which are difficult to access.

Fig 4: Pressing Ear Clip
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Gap (A) max. 1 mm!

Fig 5: Checking Ear Clip Gap
Courtesy of BMW OF NORTH AMERICA, INC.