26 11 090 Removing and installing /replacing centering mount for propeller shaft

WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 5 500
11 1 310
11 2 030 See ENGINE - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove propeller shaft .

Fill centering bore (1) completely with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centering bore.

The centering mount (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

NOTE: To drive out the mount, you can also fill the centering bore with water instead of grease.

Fig 1: Inserting Special Tool With Plastic Hammer Into Centering Bore

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove grease/water from mount bore.

Drive in centering (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centering mount.

Fig 2: Installing Centering Mount Into Propeller Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe protrusion A = 4⁺² mm of centering (1).

Fig 3: Inspecting Centering Mount Installation Position

Courtesy of BMW OF NORTH AMERICA, INC.