61 61 270 Removing and installing console for windshield wiper system completely with motor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
IMPORTANT:
Before fitting windshield wiper arms, allow wiper motor to run into rest position.
Release screws (1).
Installation:
Tightening torque 61 61 15AZ .
Remove cross-strut bearing block (2) in direction of arrow.
Unfasten plug connection (1) and disconnect.
Release screws (A5...A1).
Installation:
Insert screws (A1...A5) in specified sequence until hand-tight.
To tighten down screw (A2), if necessary move complete wiper console linkage (2) into reversal position.
Tighten down screws (A1...A5) in specified sequence to tightening torque 61 61 6AZ .
Lever out complete wiper console (2) in direction of arrow.