61 31 342 Removing and installing/replacing gear selector switch

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD
Remove TRIM FOR STORAGE COMPARTMENT

Disconnect plug connection (1).

Release screws (3) and lay emergence release mechanism to one side. Tightening torque 61 31 7AZ .

Release screws (2). Tightening torque 61 31 6AZ .

Remove gear selector switch (4) from center console (5).

Installation:

Align gear selector switch (4) centrally.

Fig 1: Identifying Plug Connection, Gear Selector Switch And Centre Console

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Modify spacer bolt.

Carry out VEHICLE PROGRAMMING/CODING .