00 7 500 Universal puller Kukko 17/K

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For removing bearing inner race from drive flange at rear wheel bearing

Series: E12, E21, E23, E24, E28, E30, E30/C, E30tou, E31, E32, E32/3, E34, E34tou, E36, E36/2, E36/3, E36/5, E36/7, E36/C, E36tou, E38, E38/3, E39, E39PL, E39tou, E46, E46/16, E46/2, E46/3, E46/5, E46/C, E52, E53, E60, E61, E63, E64, E65, E66, E67, E68, E70, E81, E82, E83, E85, E86, E87, E90, E91, E92, E93, R50, R52, R53, R55, R56, RR1, RR2

Fig 1: Identifying Special Tool - 00 7 500 Universal Puller Kukko 17/K

Courtesy of BMW OF NORTH AMERICA, INC.

Order number: 00 7 500

Universal puller Kukko 17/K

Consisting of:

1 = 00 7 501 Pressure spindle with bridge

2 = 00 7 502 Adjusting spindle (2 x) with knurled nuts (4 x)

3 = 00 7 503 Pressure spindle, side

4 = 00 7 504 Adjusting jaws (2 x)

5 = 00 7 505 Adjusting screws (2 x) with nuts

NOTE: For adjusting jaw (2 x)

6 = 00 7 506 Extension (2 x)

7 = 00 7 507 Bridge