Torque Specifications
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Center Mount-To-Body | 15 (21) | ||
| Driveshaft-To-Drive Flange (Rear Axle) | |||
| Version, Universal Joint: Compression Nut | 47 (64) | ||
| Version, Universal Joint: Torx Bolt | 63 (85) | ||
| Version, Constant-Velocity Joint: Compression Nut M8 Thread | 24 (32) | ||
| Compression Nut M10 Thread | 47 (64) | ||
| Finned Nut M8 Thread | 32 (43) | ||
| Finned Nut M10 Thread | 52 (70) | ||
| Flexible Disk-To-Propeller Shaft & Transmission Output Flange (Steel) | |||
| M10 8.8 Thread | 35 (48) | ||
| M10 10.9 Thread | 47 (64) | ||
| M12 10.9 Thread | 66 (90) | ||
| Reinforcement Plate-To-Front Axle Support/Engine Carrier | |||
| Step 1 | 41 (56) | ||
| Step 2 | Additional 90° | ||
| Step 3 | Additional 15° | ||
| Rubber Mounts-To-Cross Member Or Transmission | 15 (21) | ||
| Torque Converter-To-Flywheel | 33 (45) | ||
| Transmission Cross-Member-To-Body | 15 (21) | ||
| Transmission-To-Engine | |||
| Hex Screws | |||
| M8 Thread | 18 (24) | ||
| M10 Thread | 33 (45) | ||
| M12 Thread | 60 (82) | ||
| Torx Bolts | |||
| M8 Thread | 15 (21) | ||
| M10 Thread | 31 (42) | ||
| M12 Thread | 53 (72) | ||
| INCH Lbs. (N.m) | |||
| Clamping Screw On Shift Lever | 89 (10) | ||