13 62 Senders for Control Unit
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - SENDERS FOR CONTROL UNIT
| Type | Measure | |
|---|---|---|
| 1AZ Temperature time switch | M21 / M51 | 18 Nm |
| 2AZ Temperature sensor, water | M60/1 / M60/2 / M21 / M51 | 18 Nm |
| all others | 13 Nm | |
| 3AZ Temperature switch | All | 28 Nm |
| 4AZ Temperature sensor, air | All | 13 Nm |
| 5AZ Charge-air pressure sensor to bracket | M51 / M41 | 4 Nm |
| Charge-air pressure sensor to intake manifold | M47 | 5 Nm |
| 6AZ Dual temperature sensor (4-pin plug connection) | M41 / M43 / M44 / S50 / S52 / M52/ M57 / M67 / M62 / M73 | 13 Nm |
| 7AZ Air-mass sensor on lower section of intake filter housing | M51 | 3.5 Nm |
| Air-mass flow sensor to cylinder head cover | M47 / M47TU / M57 / M57TU / M57T2 | 4.5 Nm |
| 8AZ Pulse generator, camshaft to cylinder head cover | M57 | 4.5 Nm |
| M47TU / M57TU | 3.5 Nm | |
| M57T2 | 2.3 Nm | |
| 9AZ Intake neck on air-mass flow sensor | M47 | 9 Nm |
TIGHTENING TORQUE SPECIFICATIONS - SENDERS FOR CONTROL UNIT
| Type | Thread | Measure | |
|---|---|---|---|
| 1AZ Camshaft sensor to cylinder head | N52 / N52K / N53 | M6 x 16 | 8.8 Nm |
| 2AZ Crankshaft sensor to crankcase | N52 / N52K / N53 | M6x16 | 3 Nm |
| 3AZ Knock sensor to crankcase | N52 / N52K / N53 | M8x31 | 10 Nm |
| 4AZ Differential pressure sensor to intake manifold | N52 / N52K / N53 | K50x20 | 6 Nm |
| 5AZ Water temperature sensor, screwed | N52 / N52K / N53 | M12x1.5 | 13.5 Nm |
| 6AZ Magnet wheel to eccentric shaft | N52 / N52K / N53 | M6x20 | 8 Nm |
| 7AZ VVT sensor to bearing bridge | N52 / N52K / N53 | M6x14 | 8 Nm |
| 8AZ Air mass sensor | N52 / N52K / N53 | 3 Nm |