23 00 Transmission in general

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION IN GENERAL

	Type	Thread	Measure
2AZ Transmission to clutch housing	B/C/D/E/F/G/H/I/J-transmission	M12	76 Nm
3AZ Reinforcement plate to transmission	B/C/D/E/F/G/H/I/J-transmission	M8	23 Nm
4AZ Oil drain plug / filler plug	B/C-transmission		50 Nm
	D/E-transmission		52 Nm
	G/H-transmission	M 18x1.5 hexagon socket	35 Nm
	H/I-transmission	M 12x1.5	25 Nm
	J-transmission		40 Nm
5AZ Transmission extension	g/H transmission	M10	46 Nm

TIGHTENING TORQUE SPECIFICATIONS - TRANSMISSION IN GENERAL

	Type	Thread	Tightening specification	Measure
1AZ Transmission to engine Transmission designations, see
Hex screws	B/C/D/E/F/G/H/I/J-transmission	M6		9 Nm
	B/C/D/E/F/G/H/I/J-transmission	M8		25 Nm
	B/C/D/E/F/G/H/I / J-transmission	M10		49 Nm
	B/C/D/E/F/G/H/I/J-transmission	M12		74 Nm
Torx bolt	B/C/D/E/F/G/H/I/J-transmission	M6		9 Nm
	B/C/D/E/F/ J-transmission	M8		22 Nm
	B/C/D/E/H/ I / J transmission	M10		43 Nm
	G transmission	M10		38 Nm
	J-transmission	M 10x55 8.8		43 Nm
	J-transmission	M 10x42 8.8		42 Nm
Steel screws with Torx head	I/G/H-transmission	M8		19 Nm
Steel screws with Torx head	I/G/H-transmission	M12		66 Nm
2AZ Transmission to N52/N52K/N53/N54 aluminum screws marked blue	I/ G/ H-transmission		Replace screws Jointing torque and angle of rotation must be observed without fail
	I / G / H-transmission	M10x30	Jointing torque	20 Nm
			Torque angle	90-110°
	I / G / H-transmission	M10x85	Jointing torque	20 Nm
			Torque angle	180-200°
	I / H / G-transmission	M12	Jointing torque	25 Nm
			Torque angle	130°
3AZ Cover plate, transmission	I/H-transmission	M6		8 Nm