51 24 Rear lid locks
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - REAR LID LOCKS
| Type | Tightening specification | Measure | |
|---|---|---|---|
| 1AZ Banjo bolt to hydraulic unit and to hydraulic cylinder | E39/ Touring | 1 0+2.5 Nm | |
| E65/ E66/ E67 | 15 Nm | ||
| 2AZ Oil filler plug to hydraulic unit | E65/ E66/ E67/ E39/ Touring | 8+2 Nm | |
| E61 | 1+0.3 Nm | ||
| 3AZ Engine bolt to hydraulic unit | E65/ E66/ E67 | 5+1.52 Nm | |
| 4AZ Hydraulic unit to bracket | E61 | 2+ +1.5 Nm | |
| E65/ E66/ E67 | 10 Nm | ||
| 5AZ Rear lid lock to rear lid | E60/ E63/ E64/ E65/ E66/ E67/ E85/ E86 | 10 Nm | |
| 6AZ Striker to body | E60/ E63/ E64/ E65/ E66/ E67/ E85/ E86 | 10 Nm | |
| 7AZ Bracket, hydraulic unit, to body | E65/ E66/ E67 | 10 Nm | |
| 8AZ Bracket, angle sensor, to body | E65/ E66/ E67 | 7 Nm | |
| 9AZ Valve to hydraulic unit | E65/ E66/ E67 | 14 Nm | |
| 10AZ Ball pin for hydraulic cylinder to body | E61 | Install with Loctite 270 | 41 Nm |