51 61 Reinforcement, body
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - REINFORCEMENT, BODY
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Tension strut in engine compartment | E60/ E61 / E63/ E64 | M8 | Replace screws | |
| Screw connection again | 27 Nm | |||
| New component/ initial screw connection | 30.5 Nm | |||
| 2AZ Structural tension strut, front | E64 | M12 | Replace screws | |
| Jointing torque | 100 Nm | |||
| Torque angle | 90° | |||
| E64 | M6 | Replace screws | ||
| Jointing torque | 8 Nm | |||
| 3AZ Tension strut to rear axle | E60/ M5, E61 / M5, E63/ M6, E64 / M6 | M8 | M8 8.8 | 24 Nm |
| M8 10.9 | 30 Nm | |||
| E61, E64 | M12 | Replace screws | ||
| Jointing torque | 100 Nm | |||
| Torque angle | 90° | |||
| E61, E64 | M8 | Nut | 19 Nm | |
| 4AZ Tension strut, rear axle, front | E61 / M5, E64 / M6 | M12 | Replace screws | |
| Jointing torque | 100 Nm | |||
| Torque angle | 90° | |||
| 5AZ Tension strut, rear axle, rear | E61 / M5, E64 / M6 | M12 | Replace screws | |
| Jointing torque | 100 Nm | |||
| Torque angle | 90° | |||
| 6AZ Cross strut/rear | E61, E64 | M10 | Nuts | 41 Nm |
| Screws | 59 Nm | |||
| 7AZ Connecting carrier to body (tunnel) | E60, E61, E63, E64, E87, E88, E90, E91, E92/ S65, E93 | M8 | 24 Nm | |
| E65, E66 | M8 | 19 Nm | ||
| E83 | M8 | 23 Nm |