52 26 008 Removing And Installing/Replacing Left/Right Sides Of Backrest On Rear Seat Backrest (Through-Loading)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Pull seat belt to middle and place behind head restraint.

Pull top backrest side section (1) forwards (unclip) remove towards top (2).

Fig 1: Removing Towards Top

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pull clip (1) forwards out of sheet metal.

Fig 2: Pulling Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check clip (1) and mount (2) for damage.

Slide clip (1) into mount (2) of backrest side section.

Fig 3: Sliding Clip Into Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

First feed guides (1 and 3) on backrest side section into mounts (2 and 4) of body.
Then press backrest side section downwards so that guides are correctly seated in mounts.
To finish, clip in backrest side section at top.

Fig 4: Identifying Feed Guides And Mounts
Courtesy of BMW OF NORTH AMERICA, INC.