52 17 380 Removing And Installing/Replacing Head Restraint Mount On Left Or Right Front Seat (Comfort)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove HEAD RESTRAINT .
Remove BOTH REAR panels on front seat backrest.

Detach retaining points (1).

Fig 1: Identifying Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten cable clip (1).

Disconnect plug connections (2).

Feed out AKS carrier (3) towards bottom.

Fig 2: Identifying Plug Connections, Cable Clip And AKS Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation:

Guide pins (2) of head restraint mount must engage in openings on AKS carrier.

Feed out head restraint mount (3) sideways.

Fig 3: Identifying Screws, Guide Pin And Restraint Mount

Courtesy of BMW OF NORTH AMERICA, INC.