52 17 205 Removing And Installing/Replacing Both Rear Panels On Left Or Right Front Seat Backrest (Long Version)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Rear panel upper section:

Reach between rear panel and backrest cover and unclip rear panel upper section.
Remove rear panel towards top.

Installation:

Engage rear panel correctly in guide.

Retainers must not be damaged and must be preinstalled.

Fig 1: Removing Rear Panel Towards Top

G04742877

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Detach wiring harness retainers from rear panel.

Fig 2: Locating Plug Connections

G04742878

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Release screws (1).

Remove monitor (2).

Unlock trim (3) with button and remove.

Fig 3: Locating Unlock Trim

G04742879

Courtesy of BMW OF NORTH AMERICA, INC.

Rear panel trim lower section:

Reach between rear panel and backrest cover and unclip rear panel lower section.

Installation:

Retainers must not be damaged and must be preinstalled.

Fig 4: Identifying Rear Panel Lower Trim

G04742880

Courtesy of BMW OF NORTH AMERICA, INC.

Only when replacing on passenger side:

Unlock seat adjustment switch (1) and remove.

Fig 5: Locating Seat Adjustment Switch

G04742881

Courtesy of BMW OF NORTH AMERICA, INC.