52 14 060 Removing And Installing/Replacing Valve Housing For Left Or Right Front Lumbar Support (Normal/Electric)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove REAR PANEL on front seat backrest

Release retaining screw (1).

Disconnect electrical plug connection.

Fig 1: Identifying Retaining Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect air hoses (1) and (2).

Installation:

Make sure air hoses (2) are correctly connected to valve block (color coding: red/blue).

Housing on valve block must not be unclipped (leakage). If necessary, clip housing together.

Fig 2: Identifying Air Hoses

Courtesy of BMW OF NORTH AMERICA, INC.