52 14 010 Removing And Installing/Replacing Both Seat Rails On Left Or Right Front Seat (Normal/Electric)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT SEAT
Remove LOWER STRAP (belt tensioner)
Remove DRIVE UNIT for longitudinal seat adjustment

WARNING:

Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.

Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Switch off ignition!

Disconnect all plug connections on seat and airbag modules.

Installation:

Ensure correct connection; mark plug connections if necessary.

Fig 1: Identifying Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Press catches (1).

Slide adjusting unit (2) for active head restraint adjustment in direction of arrow and remove.

Fig 2: Identifying Catches And Adjusting Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Release left and right screws (1).

Tightening torque: 52 10 6AZ . See FRONT SEATS for specs.

Remove seat rails (4) with carrier plate (3).

Release fastening elements (2) on left and right.

Remove carrier plate (3).

Fig 3: Identifying Screws, Rails, Carrier Plate And Elements

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove holder (2) for lower strap (belt tensioner).

Fig 4: Identifying Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.