67 62 020 Removing And Installing/Replacing Flat Motor For Rear Left Or Right Power Window Regulator

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Detach SOUNDPROOFING ON REAR DOOR in working area.

Unfasten plug connection (1) and disconnect.

Release screw (2) of locking bar (3).

Remove locking bar (3) in direction of arrow from flat motor for power window unit (5).

Release screws (4).

Carefully press flat motor for power window unit (5) towards rear out of mounting.

If necessary, pull power window unit forwards slightly and feed out flat motor for power window unit (5) and remove.

Fig 1: Removing Locking Bar From Flat Motor For Power Window Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guides (1) are correctly seated when fitting retaining clip (2).

Fig 2: Identifying Guides And Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

INITIALISE power window.

NOTE:

Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).