67 31 540 Removing And Installing/Replacing Drive Unit For Head Restraint Adjustment (Comfort Seat)

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT SEAT .
Remove BOTH REAR PANELS ON FRONT SEAT BACKREST .

Pull backrest cover (1) in direction of arrow over metal lugs (2) and detach.

If necessary, detach backrest cover (1) on both sides from backrest frame.

Fig 1: Detaching Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

For purposes of clarity, illustration shows backrest cover removed.

Release screw connections (1) on AKS carrier.

Fig 2: Identifying Screw Connections On AKS Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Move AKS carrier (1) in direction of arrow.

Unhook backrest cover (2) on backrest frame (3).

Fig 3: Unhooking Backrest Cover On Backrest Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Pull drive shaft (1) in direction of arrow out of drive shaft receptacle (2).

Installation:

Make sure drive shaft (1) is correctly seated in receptacle (2).

Disconnect plug connection (3).

Remove circlip (4).

Feed out drive unit for backrest head adjustment (5) and remove.

Fig 4: Pulling Drive Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Removal and installation only:

Do not turn spindle (1) in order not to change measurement A.

Replacement only:

Adopt measurement A of removed drive unit for backrest head adjustment (2). If necessary, adjust measurement A by turning spindle (1).

Fig 5: Adjusting Measurement By Turning Spindle

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

INITIALIZE drive unit for backrest head adjustment.