63 25 000 Removing And Installing/Replacing Auxiliary Brake Light

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Unclip cover for auxiliary brake light (1) at points (2) and feed out sideways in direction of arrow.

Remove cover for auxiliary brake light (1) from moulded roofliner (3).

Fig 1: Identifying Auxiliary Brake Light And Moulded Roofliner

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) and locators (2) must not be damaged.

Make sure cover for auxiliary brake light (3) is correctly seated.

Fig 2: Identifying Clips, Locators And Brake Light

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

If necessary, unclip plug connections (2) on auxiliary brake light (4).

Unlock slide (3) on both sides and remove auxiliary brake light (4) in direction of arrow from rear window (5).

Installation:

Make sure auxiliary brake light (4) is correctly positioned in rear window (5).

Fig 3: Identifying Plug Connections And Brake Light

Courtesy of BMW OF NORTH AMERICA, INC.