61 61 010 Checking/Adjusting Contact Angle Of Windscreen Wiper Arms On Windscreen

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

NOTE: Wipe quality is improved by precise adjustment of CONTACT/APPROACH ANGLE of wiper arms.
Adjustment angle can be checked with special tool 00 9 331 or 61 6 100 .

Checking with setting gauge:

Remove load from windscreen wiper blades (1) before checking contact angle. To do so, lift wiper blades (1) briefly off windscreen before placing them back on windscreen.

Fit special tool 00 9 331 as illustrated on wiper arm and windscreen.

When the contact angle is correctly adjusted, no light gap is visible between special tool 00 9 331 and the wiper arm.

If necessary, adjust wiper arm.

Fig 1: Identifying Special Tool (00 9 331)

Courtesy of BMW OF NORTH AMERICA, INC.

Checking with angulometer:

Remove wiper blades.

Insert windscreen wiper arm (1) in special tool 61 6 100 .

Using screw (2) and pressure plate (3), locate windscreen wiper arm (1) and position on windscreen.

Read off scale value, adjust wiper arm if necessary.

NOTE:

Windscreen wiper arm (1) must rest correctly on lower and side contact surfaces (4) of special tool 61 6 100 .

On right-hand-drive cars, screw (2) must be located on left side of special tool 61 6 100 .

Fig 2: Identifying Special Tool (61 6 100)

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting left wiper arm:

Unclip wiper arm cap (1) and remove in direction of arrow.

Fig 3: Removing Wiper Arm Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) of wiper arm cap (2) must not be damaged.

Make sure wiper arm cap (2) is correctly seated.

Fig 4: Identifying Catches And Wiper Arm Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) slightly.

Position windscreen wiper arm (2) with special tool 00 9 331 or 61 6 100 on windscreen.

Turn windscreen wiper arm (2) in direction of arrow until contact angle is correct.

Hold wiper arm (2) in this position and tighten down nut (1).

Installation:

Tightening torque: 61 61 12AZ . See WINDSCREEN WIPERS for specs.

Fig 5: Turning Windscreen Wiper Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting right wiper arm:

Unclip four-way linkage protective cap (1) and remove in direction of arrow.

Fig 6: Removing Four-Way Linkage Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) of four-way linkage protective cap (2) must not be damaged.

Make sure four-way linkage protective cap (2) is correctly seated.

Fig 7: Identifying Catches And Four-Way Linkage Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) slightly.

Position windscreen wiper arm (2) with special tool 00 9 331 or 61 6 100 on windscreen.

Turn windscreen wiper arm (2) in direction of arrow until contact angle is correct.

Hold wiper arm (2) in this position and tighten down nut (1).

Installation:

Tightening torque: 61 61 14AZ . See WINDSCREEN WIPERS for specs.

Fig 8: Turning Windscreen Wiper Arm

Courtesy of BMW OF NORTH AMERICA, INC.