61 31 238 Removing And Installing/Replacing Lane Departure Warning Motor Electrics (Standard Steering Wheel)

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect battery negative lead
Remove AIRBAG UNIT

Release screws (1) and remove retaining plate (2).

Tightening torque: 32 33 2AZ . See STEERING WHEEL for specs.

Fig 1: Removing Retaining Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release screw (2).

Release screws (3) and remove motor electrics (4) complete with electrical wires.

Installation:

Replace screws (2 and 3).

(2) Tightening torque: 32 33 3AZ . See STEERING WHEEL for specs.
(3) Tightening torque: 32 33 4AZ . See STEERING WHEEL for specs.

Ensure correct cable routing.

Fig 2: Removing Motor Electrics Complete With Electrical Wires

Courtesy of BMW OF NORTH AMERICA, INC.