54 12 270 Removing And Installing/Replacing Adjuster For Glass Slide/Tilt Sunroof Lid

REMOVE  glass sunroof lid.

Close glass sunroof lid (zero position).

Unhook lever (2) from adjuster (1).

Fig 1: Identifying Adjuster And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Locking catches (1) of lever (2) must not be damaged.

Fig 2: Locating Locking Catches And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

When glass sunroof is in zero position, marking (1) on adjuster must be positioned over marking (2) on slider.

If necessary, move adjuster or slider.

Fig 3: Identifying Mark On Slider

Courtesy of BMW OF NORTH AMERICA, INC.

Move glass sunroof lid into "lift position".

Pull adjuster (3) and carriage (1) together towards rear until adjuster (3) can be unhooked from slider (2).

Grip slider (2) in so doing.

Fig 4: Identifying Adjuster, Carriage And Slider

Courtesy of BMW OF NORTH AMERICA, INC.

Twist adjuster (1) upwards.

Fig 5: Identifying Adjuster

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook adjuster (1) from carriage (2).

Fig 6: Identifying Adjuster And Carriage

Courtesy of BMW OF NORTH AMERICA, INC.