72 60 057 Removing And Installing/Replacing Ski Bag

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Fold center armrest downwards.

Unlock cover lid (1) by pulling on handle (2) and fold downwards.

Fig 1: Pulling Handle

Courtesy of BMW OF NORTH AMERICA, INC.

Release locks on trim (1) with a screwdriver (2).

Remove trim (1).

Fig 2: Identifying Locks Trim With Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and (2).

Installation:

Insert screw (2) in nut on retaining strap for ski bag.

Fig 3: Identifying Retaining Strap Ski Bag

Courtesy of BMW OF NORTH AMERICA, INC.

Remove ski bag cassette (1) in direction of arrow from rear partition.

Fig 4: Removing Ski Bag Cassette

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, perform this work step with assistance of a second person.

Ski bag cassette (3):

insert with locking lugs (2) into openings (1)
press against rear partition
slide to left until locking lugs (2) snap into place
insert screws from passenger compartment and tighten down.

Fig 5: Identifying Locking Lugs
Courtesy of BMW OF NORTH AMERICA, INC.