72 12 000 Removing And Installing/Replacing Airbag Module On Passenger Side

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe safety regulations for handling airbag modules and pyrotechnical seatbelt tensioners. See 72 00 ... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
Incorrect handling can activate airbag and cause injury.

Follow instructions for disconnecting and connecting battery! See 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .

Disconnect battery negative lead.

Remove glovebox.

Version with CD changer:

Remove CD changer.

Unfasten plug connection (3) and disconnect.

Release screws (4).

Lay retaining clip (2) slightly to one side.

IMPORTANT: Airbag module (1) could fall out after screws (5) have been released. Grip airbag module (1).

Release screws (5) and carefully remove airbag module (1).

Fig 1: Identifying Airbag Module Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

When inserting airbag module (4) in channel (3), make sure channel (3) rests all round airbag module (4). If necessary, pull channel (3) apart at sides.

Replace screws (1).

Retainers (2) fall out during removal and do not have to be replaced.

Tightening torque. See PARTS AND ACCESSORIES - TIGHTENING TORQUES - ALPINA .

Fig 2: Identifying Airbag Module Retainers And Screws

Courtesy of BMW OF NORTH AMERICA, INC.