67 66 012 Removing And Installing/Replacing Drive Unit For Lumbar Support On Left Or Right Front Seat (Comfort Seat)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both rear panels on front seat . See 52 17 205 REMOVING AND INSTALLING/REPLACING BOTH REAR PANELS ON LEFT OR RIGHT FRONT SEAT BACKREST (COMFORT) .

If necessary, unhook backrest cover (1) from backrest.

Cut through cable ties (2).

Unclip wiring harness at point (3) towards front.

Release screw (4) and feed out valve unit (5) towards top.

Fig 1: Identifying Valve Unit, Cable Ties And Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through cable tie (1).

Push jacket of drive unit for lumbar support (2) in direction of arrow over drive unit for lumbar support (3).

Fig 2: Pushing Jacket Of Drive Unit For Lumbar Support Over Drive Unit For Lumbar Support

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Detach hose (2).

NOTE: If firmly seated, gently heat hose (2) on drive unit for lumbar support (3).

Installation:

Make sure hose (2) is laid without kinks.

Remove drive unit for lumbar support (3).

Replacement:

Pull drive unit for lumbar support (3) out of jacket (4).

Fig 3: Identifying Jacket, Lumbar Support, Hose And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.