67 65 019 Removing And Installing/Replacing Drive For Left Or Right Roller Sun Blind

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Remove and install rear door trim. See 51 42 000 REMOVING AND INSTALLING LEFT OR RIGHT REAR DOOR TRIM PANEL .

NOTE: Removal is shown on drive for roller sun blind (door window). Roller sun blind (fixed door window) is removed in same way.

Unlock plug connection (1) and disconnect.

Release screws (2).

Installation:

Observe tightening torque. See ELECTRICAL DRIVES - TIGHTENING TORQUES -- ALPINA .

Remove drive for roller sun blind (3) in direction of arrow.

Fig 1: Removing Drive For Roller Sun Blind

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Toothing (1) of drive for roller sun blind (2) must be placed exactly on shaft (3).

Fig 2: Identifying Toothing Of Drive For Roller Sun Blind

Courtesy of BMW OF NORTH AMERICA, INC.