67 62 020 Removing And Installing/Replacing Flat Motor For Rear Left Or Right Power Window Regulator

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove function carrier in rear door . See 51 22 035 REMOVING AND INSTALLING FUNCTION CARRIER (WITHOUT ROLLER SUN BLIND) ON LEFT OR RIGHT REAR DOOR or 51 22 435 REMOVING AND INSTALLING FUNCTION CARRIER (WITH ROLLER SUN BLIND) ON LEFT OR RIGHT REAR DOOR .

Unlock plug connection (1) and disconnect.

Release screws (2), tightening torque. See BODY EQUIPMENT - TIGHTENING TORQUES - ALPINA .

Slacken screw (3) on retaining clip.

Press flat motor for power window (4) towards rear out of mounting and feed out in direction of arrow.

Fig 1: Removing Flat Motor For Power Window

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guides (1) are correctly seated when fitting retaining clip (2).

Fig 2: Identifying Retaining Clip And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Initialize power window. See 67 62 ... NOTES ON INITIALIZING POWER WINDOW .