67 62 000 Removing And Installing/Replacing Flat Motor For Front Left Or Right Power Window

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove function carrier in front door . See 51 21 035 REMOVING AND INSTALLING/REPLACING FUNCTION CARRIER ON LEFT OR RIGHT FRONT DOOR .

Unlock plug connection (1) and disconnect.

Release screws (2), tightening torque. See BODY EQUIPMENT - TIGHTENING TORQUES - ALPINA .

Slacken screw (3) on retaining clip.

Press flat motor for power window (4) towards rear out of mounting and feed out in direction of arrow.

Fig 1: Removing Flat Motor For Power Window

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guides (1) are correctly seated when fitting retaining clip (2).

Fig 2: Identifying Retaining Clip And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Initialize power window. See 67 62 ... NOTES ON INITIALIZING POWER WINDOW .