67 61 005 Removing And Installing (Replacing) Drive With Gear For Actuating Slide/Tilt Sunroof

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front console insert . See 61 31 175 REMOVING AND INSTALLING/REPLACING SWITCH FOR SLIDE/TILT SUNROOF .

NOTE: Secure drive with gear for actuating slide/tilt sunroof (2) against falling out.

Release screws (1).

Remove drive with gear for actuating slide/tilt sunroof (2) and disconnect plug connection (3).

Installation:

Replace screws (1).

Fig 1: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert gear wheel (1) of drive for actuating slide/tilt sunroof (2) in gear teeth (3).

Fig 2: Identifying Gear Wheel Of Drive For Actuating Slide/Tilt Sunroof

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Initialize drive for actuating slide/tilt sunroof . See 54 0 ... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE)

IMPORTANT: Replacement
Observe notes and instructions in HLI VK6229. (PuMA measure)

Replacement:

Carry out programming/coding . See VEHICLE PROGRAMMING AND CODING .

IMPORTANT: There is a risk of permanent battery discharge if programming/coding is not carried out!