67 33 510 Removing And Installing/Replacing SERVOLOCK Drive
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove trim for tail panel at top . See 51 46 050 REMOVING AND INSTALLING / REPLACING TRIM FOR REAR PANEL AT TOP .
Unfasten plug connection (1) and disconnect.
Turn plug housing (2) approx. 45° in direction of arrow and unclip.
Release screws (3) and remove servolock drive (4).
Installation:
- Adjust rear lid lock . See 51 24 004 ADJUSTING REAR LID LOCK (LOWER SECTION OF REAR LID LOCK) .