67 31 610 Removing And Installing/Replacing Drive For Seat Tilt Adjustment (Comfort Seats In Rear Compartment)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Remove rear seat padding completely . See 52 25 002 REMOVING AND INSTALLING PADDING FOR LEFT OR RIGHT REAR SEAT .

Disconnect plug connection (1). If necessary, cut through cable tie.

Release screws (2).

Detach drive for seat tilt adjustment (3) from drive shaft (4) and feed out in direction of arrow.

Installation:

Make sure drive shaft (4) is correctly seated.

Fig 1: Removing Drive For Seat Tilt Adjustment From Drive Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Initialize drive unit for seat tilt adjustment. See 67 31 ... NOTES ON INITIALIZING ELECTRIC SEAT SERVODRIVES .