66 54 511 Replacing Night Vision Camera

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

IMPORTANT: New component contains a CD with deblocking code.
Deblocking code CD is requested during coding/programming by the SSS.
Coding/programming without the deblocking code CD is not possible!

Necessary preliminary tasks:

Remove night vision camera . See 66 54 010 REMOVING AND INSTALLING COMPLETE NIGHT VISION CAMERA .

Release screw (1) on both sides.

Remove camera (2) from holder (3).

Fig 1: Identifying Camera And Holder

G04762019

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert camera (1) in holder (2).

Left guide pin (3) must be correctly seated in holder (2).

Apply screw securing adhesive to screw (4) and tighten screw.

Fig 2: Identifying Guide Pin, Camera And Holder

G04762020

Courtesy of BMW OF NORTH AMERICA, INC.

Tab (1) must snap noticeably into holder (2).

Make sure guide pin (3) is correctly seated in holder.

Apply screw securing adhesive to screw (4) and tighten screw.

Fig 3: Identifying Guide Pin, Tab And Holder

G04762021

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carry out coding/programming . See VEHICLE PROGRAMMING AND CODING .
Adjust night vision camera . See 66 54 001 ADJUSTING NIGHT VISION CAMERA .