65 77 750 Removing And Installing (Replacing) Driver's Seat Sensor
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Note airbag safety instructions
!
Incorrect handling can activate airbag and cause injury. See 51 00 ... SAFETY INSTRUCTIONS FOR WORKING ON CARS WITH AIRBAG SYSTEMS .
Incorrect handling can activate airbag and cause injury. See 51 00 ... SAFETY INSTRUCTIONS FOR WORKING ON CARS WITH AIRBAG SYSTEMS .
NOTE:
To facilitate installation/removal of sensor, move seat upwards fully.
NOTE:
Follow instructions for handling optical fibers.
See61 00 ... NOTES ON HANDLING OPTICAL FIBERS
.
Necessary preliminary tasks:
- Disconnect negative battery cable. See 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD .
Unclip trim in upper rail at front (1) in direction of arrow and remove.
Unlock plug connections (1) and disconnect.
Unlock catches (2).
Installation:
Make sure driver's seat sensor (3) is correctly engaged.
Feed out driver's seat sensor (3) in direction of arrow and remove.
Replacement:
Carry out coding/programming. See VEHICLE PROGRAMMING AND CODING .
Observe following IDC specifications:
- Programming
- Coding
- Car & Key Memory
- CD "CIP"