65 24 020 Removing And Installing Or Replacing Blocking Circuit

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove trim on C-pillar at bottom right . See 51 43 230 REMOVING AND INSTALLING / REPLACING TRIM ON C-PILLAR AT BOTTOM LEFT OR RIGHT .

NOTE: For purposes of clarity, the illustration shows the panel for the rear parcel shelf removed.

Disconnect plug connections (1).

Release screw (2) and remove blocking circuit (3) in direction of arrow from rear window antenna amplifier.

Fig 1: Removing Blocking Circuit

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guide pin (1) of blocking circuit (2) is correctly seated in bore in rear window antenna amplifier.

Fig 2: Identifying Guide Pin

Courtesy of BMW OF NORTH AMERICA, INC.