64 11 840 Replacing SERVODRIVE For Left FOOTWELL Flap (Automatic A/C High)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove function carrier on trim for instrument panel. See 51 16 170 REMOVING AND INSTALLING FUNCTION CARRIER ON PANEL FOR INSTRUMENT PANEL .

Unclip cover (1) at both retaining hooks (2) and remove in direction of arrow.

Fig 1: Uncliping Cover At Retaining Hooks

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip both linkages (2) in direction of arrow.

Release screws (1).

Pull back holder (3) in direction of arrow and invert.

Fig 2: Pulling Back Holder And Invert

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Press lock (2) and unclip servodrive (3) in direction of arrow.

Installation:

If necessary, align shaft of flap(s) to be actuated to position of servodrive to be installed.

Fig 3: Pressing Lock

Courtesy of BMW OF NORTH AMERICA, INC.