64 11 480 Removing And Installing/Replacing Cooler Box Button
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 64 1 020
Necessary preliminary tasks:
- Remove cooler box lid . See 64 11 478 REMOVING AND INSTALLING/REPLACING COOLER BOX LID .
WARNING:
When working with adhesive cleaners in enclosed rooms:
Ensure room is well ventilated.
Ensure room is well ventilated.
IMPORTANT:
Observe the following when handling adhesive areas:
The adhesive areas must be dry and free from dust and grease.
After cleaning, do not touch bonding area with bare hands.
The adhesive areas must be dry and free from dust and grease.
After cleaning, do not touch bonding area with bare hands.
Carefully lever out cover (1) with special tool 64 1 020 at marked areas.
Disconnect plug connection.
Installation:
Remove coarse adhesive residues from adhesive area of cooler box and degrease with adhesive cleaner.
Make sure button and cover (1) are correctly installed.
Press down cover (1) evenly.