63 25 000 Removing And Installing/Replacing Additional Stop Light

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Lever out catches (1) of ventilation louver for oddments tray (2).

Fold up complete ventilation louver for oddments tray (2) in direction of arrow, disconnect plug connection underneath and remove complete ventilation louver for oddments tray (2) towards front.

Fig 1: Identifying Catches And Oddments Tray

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure ventilation louver for oddments tray is correctly fed:

into mounts for oddments tray (1)
into positions (2) of oddments tray (3)

Fig 2: Identifying Oddments Tray
Courtesy of BMW OF NORTH AMERICA, INC.

Unclip additional stop light (1) in direction of arrow from ventilation louver for oddments tray (2) and remove.

Installation:

Make sure additional stop light (1) is correctly engaged in ventilation louver for oddments tray (2).

Fig 3: Identifying Additional Stop Light And Oddments Tray

Courtesy of BMW OF NORTH AMERICA, INC.