63 21 300 Replacing Circuit Board For Left Or Right Rear Light (From 03/2005) (On Side Panel)

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear light . See 63 21 180 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT REAR LIGHT (ON SIDE PANEL) .

Disconnect plug connections (3).

Open catch (2) and fold out circuit board (1).

Installation:

Make sure circuit board (1) is correctly seated on supports (4).

Fig 1: Identifying Circuit Board, Catch And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2).

Remove circuit board for rear light (1) from rear light.

Fig 2: Identifying Rear Light And Screws

Courtesy of BMW OF NORTH AMERICA, INC.