61 12 180 Replacing Wiring Harness On Function Carrier On Left Or Right Front Door
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Overview of function carrier components:
- Control unit, front door (door module)
- Light module (build date up to 09/2004)
- Sensor, front door
- Bowden cable
- Speaker
- Wiring harness, function carrier
- Quick-release coupling grey 1.8 mm
Quick-release coupling white 0.8 mm
Necessary preliminary tasks:
- Remove function carrier in front door . See 51 21 035 REMOVING AND INSTALLING/REPLACING FUNCTION CARRIER ON LEFT OR RIGHT FRONT DOOR .
- Remove control unit in front door . See 61 35 220 REMOVING AND INSTALLING (REPLACING) CONTROL UNIT FOR LEFT OR RIGHT FRONT DOOR .
- Disconnect sensor plug connection for front door . See 65 77 740 REMOVING AND INSTALLING (REPLACING) LEFT FRONT DOOR SENSOR .
- Remove speaker . See 65 13 070 REMOVING AND INSTALLING/REPLACING SPEAKER (MID-RANGE SPEAKER, DOOR AT FRONT) .
IMPORTANT:
Follow instructions for handling fibre optic cables. See 61 00 ... NOTES ON HANDLING OPTICAL FIBERS .
Risk of mixing up plugs for door lock and control unit!
Mark relevant plugs of wiring harness to be changed.
Ensure correct plug connections for replacement wiring harness through comparison of plugs (wire cross-sections, pin assignment).
Risk of mixing up plugs for door lock and control unit!
Mark relevant plugs of wiring harness to be changed.
Ensure correct plug connections for replacement wiring harness through comparison of plugs (wire cross-sections, pin assignment).
Unclip wiring harness (1).
Feed out wiring harness (1) with rubber grommet (2) and remove.