54 12 270 Removing And Installing/Replacing Adjuster For Glass Slide/Tilt Sunroof Lid

Remove  glass sunroof lid. See 54 12 115 REMOVING AND INSTALLING GLASS SLIDE/TILT SUNROOF LID .

Close glass sunroof lid (zero position).

Unhook lever (2) from adjuster (1).

Fig 1: Unhooking Lever From Adjuster

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Locking catches (1) of lever (2) must not be damaged.

Fig 2: Locking Catches Of Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

When glass sunroof is in zero position, marking (1) on adjuster must be positioned over marking (2) on slider.

If necessary, move adjuster or slider.

Fig 3: Identifying Marking On Adjuster

Courtesy of BMW OF NORTH AMERICA, INC.

Move glass sunroof lid into "lift position"

Pull adjuster (3) and carriage (1) together towards rear until adjuster (3) can be unhooked from slider (2).

Grip slider (2) in so doing.

Fig 4: Pulling Adjuster And Carriage

Courtesy of BMW OF NORTH AMERICA, INC.

Twist adjuster (1) upwards.

Fig 5: Twisting Adjuster

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook adjuster (1) from carriage (2).

Fig 6: Unhooking Adjuster From Carriage

Courtesy of BMW OF NORTH AMERICA, INC.