51 71 085 Removing And Installing Center Of Assembly Compartment Bulkhead

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both air ducts for microfilter . See 64 31 030 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT MICROFILTER AIR DUCT (AUTOMATIC A/C BASIC) or 64 31 010 REPLACING MICROFILTER FOR INTERIOR VENTILATION (AUTOMATIC A/C HIGH) .

Release screw (1) on left/right and remove both fresh air ducts.

Fig 1: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off sealing strip (1).

Unfasten screws.

Place holder (2) with switch for engine hood contact to one side.

Remove bulkhead (3).

Fig 2: Identifying Sealing Strip Holder And Bulkhead

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Do not crush cable.

Check height adjustment of engine hood contact and correct if necessary.