51 47 161 Removing And Installing / Replacing Right Luggage Compartment Wheel Arch Trim

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove trim for tail panel . See 51 46 050 REMOVING AND INSTALLING / REPLACING TRIM FOR REAR PANEL AT TOP .
Remove flap in right luggage compartment wheel arch trim. See 51 47 172 REMOVING AND INSTALLING / REPLACING FLAP IN LUGGAGE COMPARTMENT TRIM, LEFT OR RIGHT .

Lever out trim (1) in lashing eye at opening and remove.

Release screws (2) and remove lashing eye.

Fig 1: Identifying Trim And Lashing Eye Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release expansion rivets (1).

Lever out luggage compartment wheel arch trim (2) from seal (3) and remove.

Fig 2: Releasing Expansion Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Frame (1) must be correctly clipped into place on luggage compartment wheel arch trim (2).

Fig 3: Identifying Frame And Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.