51 43 201 Removing And Installing/Replacing Panel For Roof Pillar At Front (A-Pillar), Left Or Right

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

WARNING: Follow safety instructions for working on vehicles with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Lever out clip (1) with special tool 00 9 317.

If necessary, detach mucket in area of A-pillar panel.

Fig 1: Identifying Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Installation:

Tightening torque 51 43 2AZ. See BODY EQUIPMENT - TIGHTENING TORQUES -- ALPINA .

Make sure clip (2) is correctly seated.

Fig 2: Identifying Screw And Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out trim for front roof pillar towards inside/top.

Fig 3: Pulling Out Trim For Front Roof Pillar

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1 and 2) on instrument panel (3) must not be damaged.

Fig 4: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) of panel (2).

Fig 5: Identifying Clips And Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommets (1).

Do not damage head airbag (2) during installation.

Fig 6: Identifying Grommets

Courtesy of BMW OF NORTH AMERICA, INC.