51 23 160 Removing And Installing/Replacing Arrester Hook On Engine Hood

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Raise bonnet/hood lid.

Release screws (1) and remove arrester hook (2).

Tightening torque 51 23 1AZ. See BODY EQUIPMENT - TIGHTENING TORQUES -- ALPINA .

Fig 1: Identifying Arrester Hook And Screws

Courtesy of BMW OF NORTH AMERICA, INC.