51 16 367 Removing And Installing Right GLOVEBOX (With Active Knee Protector) With Housing
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with active knee protector:
Follow safety instructions for working on cars with airbag systems.
Follow safety instructions for working on cars with airbag systems.
IMPORTANT:
Do not use any sharp-edged tools to remove the glovebox (risk of damage to active knee protector).
Necessary preliminary tasks:
- Remove trim for instrument panel at bottom right . See 51 45 181 REMOVING AND INSTALLING INSTRUMENT PANEL TRIM AT BOTTOM RIGHT .
- Disconnect battery negative lead . See 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Release screws (1) and (2).
Pull glovebox (3) with housing towards rear until Bowden cable is accessible.
Version up to MY 2004:
Lever out lock (1) towards front and detach Bowden cable (2).
Version from MY 2005:
Lever out lock (1) towards rear and detach Bowden cable (2) upwards.
Unhook Bowden cable nipple (3).
Version with active knee protector:
WARNING:
Unlock and disconnect plug connection (1) for active knee protector
. See 72 12 ... DEACTIVATION OF AIRBAGS
.
Unfasten plug connection (2) and disconnect.
Remove glovebox (3).
Version without active knee protector:
Unfasten plug connection (1) and disconnect.
Remove glovebox (2).
Installation:
Adjust glovebox (1) to instrument panel (2):
A = approx. 5 mm
B = approx. 4 mm (center)
Check function.
Version with active knee protector:
IMPORTANT:
Cable (1) on glovebox (2) must not be damaged.