51 16 188 Replacing Base For Center Console On Storage Tray

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove center console carrier section . See 51 16 180 REMOVING AND INSTALLING CENTER CONSOLE CARRIER SECTION .

IMPORTANT: Set down center armrest on a suitable surface.

Release screws (1) on left/right.

Remove trim (2) in direction of arrow.

Fig 1: Identifying Screws And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Raise base (2) in direction of arrow and pull off.

Installation:

Make sure base (2) is correctly seated in guides (3).

Fig 2: Raising Base

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug housing (1) and feed out cable.

Release screws (2).

Remove center console function carrier (3).

Fig 3: Identifying Plug Housing And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove drinks holder (2) in direction of arrow.

Fig 4: Removing Drinks Holder

Courtesy of BMW OF NORTH AMERICA, INC.