51 14 110 Removing And Installing/Replacing Rear Model Designation (BMW ALPINA B7)
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be followed without fail. See 51 14 ... INSTRUCTIONS FOR ATTACHING NUMBER/LETTER DESIGNATION COMBINATION .
Stick on top edge of adhesive tape (1) parallel to trim (2) on rear lid at distance (A).
Mark measurement (B) on top edge of adhesive tape (1).
Remove liner (protective strip for adhesive surface).
Position lettering against adhesive tape (1) and press down firmly.
Dimensions:
A = 10 mm
B = 30 mm
Stick on top edge of adhesive tape (1) parallel to trim (2) on rear lid at distance (A).
Mark measurement (B) on top edge of adhesive tape (1).
Remove liner (protective strip for adhesive surface).
Position lettering against adhesive tape (1) and press down firmly.
Dimensions:
A = 10 mm
B = 50 mm