37 20 505 Removing And Installing/Replacing Dynamic Drive Holder/Valve Block
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
Seal off pipe connections with plugs.
After installation:
- Fill and bleed hydraulic system . See 34 00 050 BLEEDING BRAKE SYSTEM WITH DSC .
- Check pipe connections for leaks
- If necessary, carry out initial operation for Dynamic Drive . See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .
Necessary preliminary tasks:
- Remove valve block . See 37 20 001 REMOVING AND INSTALLING/REPLACING DYNAMIC DRIVE VALVE BLOCK .
Release screws (1).
Tightening torque. See INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES -- ALPINA .
Take off holder (2).